Connecting The Outputs - MC Crypt DJ-750 Notice D'emploi

Connection
EFFECT SEND/RECEIVE effects loop connection (46)
You can connect external effect units here.
The SEND connection sends the signal of the mixer to the effect unit. The modified signal is then sent back to the
RECEIVE connection and added to the signal path again.
Remove the two jumper plugs from the sockets.
Connect the input of the effect unit to the SEND connection. Connect the output of the effect unit to the RECEIVE
connection.
The effects loop connection is activated or deactivated via the EFFECT switch (39).
The RECEIVE effects loop connection can also be used as an additional input.
b) Connecting the outputs
OUTPUT R/L sockets (42)
Connect this output to a free TRS input of your amplifier.
This output offers better signal quality and interference resistance than OUTPUT MASTER (43) and
should therefore be favoured if the amplifier is equipped with both connection types.
Only use on of the two OUTPUT connections.
OUTPUT MASTER sockets (43)
Connect this output to a free RCA input of your amplifier.
REC sockets (45)
If you wish to record the output signal of the mixer with a recording device, connect the recording input of the device
to this socket on the mixer.
ZONE sockets (44)
You can connect an additional amplifier to this output to be used in an adjoining room or to provide the signal for
monitor loudspeakers.
HEADPHONE socket (37)
Connect headphones with a 6.3 mm TRS plug to this output.
41