Mounting The Bar And Chain - Stihl HT-KM Notice D'emploi

Mounting the Bar and Chain

Removing the chain sprocket cover
Unscrew the nut and remove the
N
cover
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns
HT-KM
Fitting the saw chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the saw chain – start at the bar
N
nose
5
1
4 3
Fit the guide bar over the screw (3)
N
and engage peg of tensioner slide in
the hole (4) – place the saw chain
over the chain sprocket (5) at the
same time
Turn the tensioning screw (1)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove
Refit the cover and screw on the nut
N
finger-tight
Go to chapter on "Tensioning the
N
Saw Chain"
English
11