Stihl HT-KM Notice D'emploi page 16

English
Hold the fuel cap down and twist it
N
clockwise until it engages
Then the markings on fuel cap and oil
tank will align
Close the bracket lock
N
14
The fuel cap is locked
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways, contact
your dealer for assistance if necessary.
STIHL recommends that maintenance
and repair work be carried out only by
authorised STIHL dealers.
If the fuel cap will not lock onto the oil
tank
The base of the fuel cap is tilted in
relation to the upper part.
Remove the fuel cap from the oil
N
tank and look at it from above
1
left: Base of fuel cap is tilted –
interior marking (1) is aligned
with the exterior marking
right: Bottom of the fuel cap in cor-
rect position – inner mark is
under the grip. It does not
align with the exterior
marking
Fit fuel cap and twist it
N
counterclockwise until it engages in
the seat of the filling port
Continue to twist the fuel cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
Twist the fuel cap clockwise and
N
close it – see section "Closing"
HT-KM