Filling Chain Oil Tank - Stihl HT-KM Notice D'emploi

Filling Chain Oil Tank

NOTICE
A full chain oil tank is sufficient for only
half a tankful of fuel. Check the oil level
regularly during cutting work. Never
allow the oil tank to run dry
Preparations
Thoroughly clean the fuel cap and
N
the area around it to ensure that no
dirt falls into the tank
Position the machine so that the fuel
N
cap is facing upwards
HT-KM
To open:
Open the bracket
N
Twist fuel cap (ca. 1/4 turn)
N
Markings on fuel cap and oil tank must
align
Remove the fuel cap
N
Filling up with chain oil
Fill up with chain oil
N
Take care not to spill chain oil during
refilling and do not overfill the tank.
STIHL recommends use of the STIHL
filling system for chain oil (special
accessory).
To close:
Clip is in an upright position:
Fit the fuel cap – marks on the fuel
N
cap and oil tank must line up.
Push the fuel cap down as far as it
N
will go
English
13