Mounting The Kombitool - Stihl FBD-KM Notice D'emploi

English
Mounting the Gearbox
1
2
Loosen the clamp screw (1) on the
N
gearbox (2) – do not remove it.
Push the drive tube (3) into the
N
gearbox, turning it back and forth at
the same time.
4
Once the end of the drive tube is
N
inserted beyond the slot in the
clamp (4), push it fully home as far
as stop.
Tighten down the clamp screw
N
moderately.
10
2
3
5
Line up the drive tube (3) in the
N
gearbox (2) so that the lug (arrow)
on the drive tube points vertically
upwards when the depth wheel (5)
is upright.
Tighten down the clamp screw
N
firmly.

Mounting the KombiTool

2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
FBD-KM