Care; External Surface; Removing The Shelf Runners; Installing And Removing The Sliding Rails - De Dietrich DOP 8360 G Guide D'utilisation

4
•

CARE

EXTERNAL SURFACE

Use a window washing product applied
to a soft cloth. Do not use abrasive
creams or scouring sponges.

REMOVING THE SHELF RUNNERS

(fig. A)
Lift the front part of the shelf runner
upwards. Press the entire shelf runner
and release the front hook from its
housing. Then, gently pull the whole of
the shelf runner towards you to release
the rear hooks from their housing. Pull
out the two shelf supports.
INSTALLING AND REMOVING THE
SLIDING RAILS (fig.B)
(depending on model)
After removing the 2 shelf runners,
choose the height (2 to 5) at which you
want to fit your rails. Snap the left rail
against the left shelf runner by applying
enough pressure to the front and back
of the rail so that the 2 tabs on the side
of the rail slot into the shelf runner. Do
the same for the right-hand rail.
NOTE: the telescopic sliding part of the
rail must unfold towards the front of the
oven, with the buffer opposite you.
Insert your 2 shelf runners and then put
your tray on the 2 rails. The system is
now ready to use.
To remove the rails, remove the shelf
runners again.
Slightly prise apart the bottom of the tabs
fixed on each rail to release the shelf
runner. Pull the rail towards you.
CLEANING THE INNER GLASS (fig. C)
Warning
Do not use scouring products,
abrasive sponges or metal scrapers
to clean the glass oven door as this
could scratch the surface and cause
the glass to shatter.
Before doing this, remove any excess
grease with a soft cloth and washing up
liquid.
Open the door fully and block it with one
of the plastic wedges provided in your
appliance's plastic pouch.
Remove the first clipped glass panel:
Using the other wedge (or a screwdriver),
press the slots
Remove the glass panel.
The door consists of two additional glass
panels, with a black rubber spacer at
each corner. If necessary, remove them
to clean them.
Do not soak the glass panels in water.
Rinse with clean water and dry off with a
lint-free cloth.
After cleaning, reposition the four rubber
stops with the arrow upwards and
reposition all of the glass panels.
Insert the last glass panel into the metal
stops, then clip it in with the side with
«PYROLYTIC» facing you and legible.
Remove the plastic wedge.
Your appliance is now ready for use
again.
18
A
to unclip the glass.