Assembly, Mounting And Installation; General Information And Safety - Ecolab Elados EMP III - E00 Manuel D'utilisation

5

Assembly, mounting and installation

Personnel:
5.1

General information and safety

NOTICE!
General instructions for installation and assembly:
– The pump must be installed at an easily accessible, frost-protected
location.
– The ambient conditions given in the "Technical data" must be observed.
– The pump must be installed in a horizontal position.
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools during assembly,
maintenance or troubleshooting. Only use the correct tools.
DANGER!
Damage and injuries may occur if installation, maintenance or repair
work is carried out incorrectly.
– All installation, maintenance and repair work may only be performed by
authorised and trained experts in accordance with valid local regulations.
– The safety regulations and the required protective clothing when working
with chemicals must be complied with. Attention must be paid to the
information included on the product data sheet for the metering medium
used.
– The metering medium supply must be isolated and the system cleaned
prior to installation, maintenance and repair work.
Electrical dangers
DANGER!
Electrical hazards are marked by the symbol opposite.
Work in these areas may only be carried out by trained personnel with the
appropriate authorisation.
n Mechanic
n Qualified electrician
n Service personnel
n Specialist
25
Assembly, mounting and installation
417102233 Rev. 3-03.2019