Parameter Level (Example); Function Control, Lead Sealing - aqua metro AMTRON E-30 Instructions De Montage Et Mode D'emploi

19.7.Parameter level (example)

The most important settings can be
carried out on this level. Other settings are
possible with the MiniCom 3 service software.
This level is protected by a password. The
password consists of the last 3 digits of the
serial number:
Serial number of the housing (8 digits)
61312
To enter password and values:
• When a number or password is shown
("000"), press key for approx. 2 seconds.
• The left segment of the display starts to
flash. The value in that segment can be
changed by keeping the key pressed down.
Release the key as soon as the desired
value is reached.
• A further short key-press confirms the
value and the next segment of the display
then flashes.
• Repeat this procedure until the last seg-
ment.
• After setting the last segment, the level is
activated or the number entered confirmed.
The next position can be selected by a short
key-press.
18
345
Password (last 3 digits)
Prompt for password *
Setting for
primary M-Bus address *
Setting for
secondary M-Bus address
*
Setting for customer-
specific number *
Setting for
averaging time period for
flow rate and power *
Setting for
data transmission mode
(One, All, F length) *

20. Function control, lead sealing

After slowly opening the shut-off valves, check
the installation for leakage.
Check the following values in the display for
plausibility as described in Sect. 7.2:
Flow rate
•
Power
•
Forward and return flow temperatures
•
The meter must be sealed with the Selflock
seals in the following places to prevent it from
being tampered with:
At both connecting pieces to the inlet and
outlet of the flow sensor
At the mounting points of the separate,
integrated temperature sensors (see also
Sect. 6)
®
AMTRON E-30 Mounting and operating instructions
Pulse value of the first
external meter
(0.25 to 10.000 l/pulse) *
Pulse value of the second
external meter
(0.25 to 10.000 l/pulse) *
Set date *
Set time *
Set billing date *
Reset maximum values *
Reset downtime time *
Reset power down time *
Return to options menu
(press for 2 seconds) *