Vacuum Pump - Snap-On ECO DUAL GAS Manuel D'instructions

11) If leaks are detected the following screen will be displayed:
Check filter tightening and press ESC to restart the vacuum check.
12) After few minutes, if no leaks are detected the following screen will be displayed:
13) Press ENTER; DRYER FILTER CHANGE is now successfully completed.

VACUUM PUMP

Perform the operations listed below on a routine basis in order to ensure good operation of the
vacuum pump:
M1) Oil top-up.
INSTRUCTIONS MANUAL
Check leaks with vacuum
- CHANGE DRYER FILTER
WARNING!
LEAKS!
Press ESC to exit
CHANGE FILTER
OPERATION COMPLETED
Unscrew the filling cap and
the drain cap then remove used oil
from vacuum pump
then press ENTER
66
DD/MM/YY XX:XX PM
STOP
DD/MM/YY XX:XX PM
ESC
DD/MM/YY XX:XX PM
ENTER
DD/MM/YY XX:XX PM
ESC
ENTER