Start Procedure - Snap-On ECO DUAL GAS Manuel D'instructions

INSTRUCTIONS MANUAL
NOTE: For most systems the quantity of fluid to be refilled is indicated on a plate that is in the
vehicle's engine compartment. If this quantity is not known, look for it in the relevant manuals.
0 ml
Select the CHARGE AMOUNT quantity field, see the keypad on the display to enter
the amount (in grams) of REFRIGERANT that will be loaded into the A / C system.
DD/MM/YY XX:XX PM
CHARGE AMOUNT
(min 100g)
_
ESC
[grams]
ENTER
NOTE: If DATABASE is installed, can be used to insert the value of refrigerant into the GAS
FILLING field.
NOTE: if gas filling is lower than 100 grams the following popup warning will be displayed:
DD/MM/YY XX:XX PM
Charge amount
Less than 100g/4oz
or unavailable quantity requested
Press ENTER to continue
ENTER
Gas charge lower than 100 grams is not allowed, press ENTER then digit an higher amount of
gas filling.

START PROCEDURE

NOTE: the STOP button literally pause the running procedure. In the final phase of the
charge the procedure hasn't to be paused or stopped to avoid to compromise the precision
of the procedure.
After selected all the procedure data, press ENTER to continue, the following screen will be
displayed:
47