Quicksetup - Snap-On ECO DUAL GAS Manuel D'instructions

The user can verify the all data of the machine:
o Check that the OIL containers aren't empty, if necessary operate the substitution
as described in ORDINARY MAINTENANCE section.
o Check that the oil level in the used oil container is < 200 cc, if necessary empty it
as described in ORDINARY MAINTENANCE section.
o Check on the machine display that there are at roughly 2 kg of refrigerant in the
tank. Should this not be the case, fill the on-board machine tank from an external
tank of appropriate refrigerant following the procedure described in the TANK
FILLING (ORDINARY MAINTENANCE)
Check that the vacuum pump oil level indicator (ref.1, Fig.13) shows at least one-half full. If
the level is lower, add oil as explained in the MAINTENANCE section.
MAX
MIN

QUICKSETUP

NOTE : The QUICKSETUP is shown after the activation of the machine
The first time the machine is used, a quicksetup guide appears: the operator is guided through
the steps described at the start of the PRELIMINARY OPERATIONS section. The quicksetup
can also be found in the SETUP MENU, select QUICKSETUP. The following screen is
displayed:
INSTRUCTIONS MANUAL
1
28
FIG. 13
TOOLS:
 Funn
el
 Disp
osal
conta
iner
 Allen
wren
ch n°
5; 8.