Standard Flange Plate; Fork Sleeves (Optional); Mounting The Optional Screw Hooks (Optional) - probst AKZ-UNI-850 Instructions De Montage

Installation
4.1.1

Standard flange plate

The device is attached to the lifting equipment/carrier with a standard flange plate or a custom made flange
plate connection.
Attaching the device to the lifting equipment/carrier take care that all local safety regulations are observed.
When attaching the device to a forklift truck, the plate with the transport ring must be unscrewed from the
flange plate. Depending on the case of use, a rotary head/rotary motor can be attached to the flange plate.
This is attached either to a fork sleeve or to a crane boom.
4.1.2

Fork sleeves (optional)

To establish a mechanical connection between the fork lift truck and the fork sleeves you have to put the
forks into the fork sleeves and fix it with the locking bolt or with a chain/rope, connected to the eyelet on the
fork sleeves and the lift frame.
It is definitely necessary to establish this connection. Otherwise the device could slide form the forks.
DANGER OF ACCIDENTS!
1
2 locking bolt
3 Fork sleeve
4 Chain/rope
4.1.3

Mounting the optional screw hooks (optional)

When using the optional screw hooks (5) on the
AKZ-UNI, ALWAYS mount all 4 screw hooks.
To ensure safe working, the 2 fastening screws of
the screw hooks must each be tightened with a
tightening torque of 85 Nm with an appropriate
tool!
5610XXXX-YYYY
Fork (of fork lift truck)
16 / 26
85 Nm
5
85 Nm
GB