Handle Height Adjustment; Propelling The Mower; Stopping The Mower - Briggs & Stratton SNAPPER 7800849B Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5

Propelling the Mower

1. Start the mower.
2. Move the ground speed control (A, Figure 6) to the desired
speed position.
3. Squeeze the wheel drive control (B) against the handle to
engage the wheel drive and propel the mower forward.
Forward speed can be adjusted while the mower is moving
by changing the position of the ground speed control.
6

Stopping the Mower

1. Stop forward motion of the mower by releasing the wheel
drive control.
2. Stop the engine and blade by releasing the blade control.
10

Handle Height Adjustment

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
The height of the mower handle can be adjusted as follows:
1. Loosen the lower nuts (A, Figure 7) on each lower handle.
2. Move the handle assembly (B) up or down until the desired
position is achieved.
3. Tighten the lower nuts on each lower handle to maintain
the desired position.
7
www.snapper.com

Publicité

Chapitres

Table des Matières
loading

Table des Matières