Installing The Grass Bag - Briggs & Stratton SNAPPER 7800849B Manuel D'utilisation

• The slot (D) on the rear of the adapter slips onto the
stud behind the rear of the discharge opening, where
the rear of the mulching cover was originally secured.
3. Install the nuts onto the studs and tighten securely.
Note: On some models, knob nuts and internal/external tooth
lock washers are used in place of nuts.
4. Route the recoil rope around the outside of the rope guide
pulley (E).
Note: The recoil rope may need to be slackened. See Starting
the Mower .
12
Installing the Mulching Plug
(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Install the mulching plug (A, Figure 13) if mulching is desired
after the bag adapter is installed. Install the mulching plug
completely and securely into the bag adapter (B).
2. Install the grass bag as a safeguard and to further secure
the mulching plug.
WARNING
Thrown Objects Hazard
Install the grass bag when using the mulching plug. Failure
to do so may result in personal injury or death.
3. See Mulching Operation .
13

Installing the Grass Bag

(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Install the grass bag adapter. See Installing the Grass
Bag Adapter .
2. Install the grass bag by sliding the connector (A, Figure 14)
over the adapter flange.
3. Attach the grass bag hooks (B) over the middle handle cross
bar.
13