Briggs & Stratton SNAPPER 7800849B Manuel D'utilisation page 23

1. Remove the pin and washer (C, Figure 29) from the transfer
rod (D), and remove the end of the transfer rod from the
hole in the driven disc assembly.
2. Using needle nose pliers, unhook the drive spring (A, Figure
32) and slide the driven disc assembly off the hex shaft.
3. Remove the five machine screws (A, Figure 33) and plate
(B) which secure the rubber ring (C) to the driven disc hub
(D).
4. Install a new rubber ring.
5. Reverse the above procedures for reassembly and
installation of the driven disc assembly.
32
33
Driven Disc Bearing Replacement
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the driven disc assembly. See Driven Disc
Replacement .
2. Remove the snap ring (A, Figure 34) that secures the driven
disc hub (B) to the thrust plate.
3. Slide the driven disc hub out of the bearing (C).
4. Remove the four screws, and replace the bearing.
5. Reassemble the components in reverse order.
Note: Be sure to replace the shim washer (D) when
reassembling the driven disc assembly.
34
23