Emptying The Grass Bag - Briggs & Stratton SNAPPER 7800849B Manuel D'utilisation

14
WARNING
Grass Catcher bags are made of woven fabric, and are subject
to deterioration and wear during normal usage. Check
condition of bag before each use. Immediately replace worn
or damaged catcher bags with only genuine replacement
bags. The grass catcher is optional equipment on some
models.

Emptying the Grass Bag

1. Grasp the bag connector and bag handle. Lift up on the bag
handle, removing it from the mower handle. Then lift up on
the bag connector, removing it from the adapter flange.
2. Open the bag by pulling the bag slider (A, Figure 15) off of
the Z-fold at the rear of the bag (B).
3. To close the bag, fold the rear of the bag into the former
Z-shape, keeping the edges aligned. Grasp the edge of the
Z-fold, and while holding the slider, pull the Z-fold fully into
the slider.
Note: An illustration of the Z-Fold is attached to the bag.
14
15
WARNING
Grass Catcher bags are made of woven fabric, and are subject
to deterioration and wear during normal usage. Check
condition of bag before each use. Immediately replace worn
or damaged catcher bags with only genuine replacement
bags. The grass catcher is optional equipment on some
models.
Maintenance
Emissions Control Service
Maintenance, replacement, or repair of the emissions
control devices and systems may be performed by any
off-road engine repair establishment or individual. However,
to obtain "no charge" emissions control service, the work must
be performed by a factory authorized dealer. See the Emissions
Control Statements.
www.snapper.com