Installing The Discharge Deflector; Installing The Grass Bag Adapter - Briggs & Stratton SNAPPER 7800849B Manuel D'utilisation

10

Installing the Discharge Deflector

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. See Mulching Operation .
2. Install the deflector (A, Figure 11) to the deck in place of
the mulching cover, making sure that:
• The front hole (B) on the outside front of the deflector
fits over the stud where the front of the mulching cover
was originally secured;
• The slot (C) on top of the deflector slips under the
restraining nut on top of the deck (under the right front
corner of the engine);
• The slot (D) on the inside rear of the deflector slips onto
the stud behind the rear of the discharge opening,
where the rear of the mulching cover was originally
secured.
3. Install the nuts onto the studs and tighten securely.
Note: On some models, knob nuts and internal/external tooth
lock washers are used in place of nuts.
12
11
WARNING
Thrown Objects Hazard
DO NOT operate without entire Grass Catcher or guard in
place. Grass Catcher components are subject to deterioration
during normal use. Inspect frequently and replace worn or
damaged components immediately.

Installing the Grass Bag Adapter

(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. See Removing the Mulching
Cover .
2. Install the adapter (A, Figure 12) to the deck in place of the
mulching cover, making sure that:
• The front hole (B) on the outside front of the adapter
fits over the stud where the front of the mulching cover
was originally secured;
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right front
corner of the engine);
www.snapper.com