Pushing The Tractor By Hand; Adjusting Mower Cutting Height; Attaching A Trailer - Briggs & Stratton Intek Série Manuel D'utilisation

Pushing the Tractor by Hand

1. Disengage the PTO and turn the engine off.
2. Pull the transmission release (A, Figure 5) to lock into
released position.
3. The tractor can now be pushed by hand.
WARNING
Towing the unit will cause transmission damage. Do
not use another vehicle to push or pull this unit. Do not
actuate the transmission release lever while the engine is
running.
Figure 5

Adjusting Mower Cutting Height

The mower lift lever (A, Figure 6) is used to lower the deck
to cutting position or raise the deck to transport position.
To lower the deck, pull back slightly on the mower lift lever,
push it to the left and slide it down. To raise the deck to
transport pull up on the mower lift lever and lock in notch to
the right. Do not cut in transport.
The cutting height adjustment knob (B) controls the mower
cutting height. The cutting height has seven positions
between 1.0" and 4.0" (2,5 and 10,2 cm). Turn the knob
clockwise to raise the deck and counterclockwise to lower
it.
Figure 6

Attaching a Trailer

The maximum trailer weight is 250 lbs (113 kg). Secure the
trailer with appropriately sized clevis pin and clip.
Stopping the Tractor and Engine
A
Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or death.
• Do not choke the carburetor to stop the engine.
1. Return the ground speed control(s) to NEUTRAL.
2. Disengage the PTO and wait for all moving parts to stop.
3. Move the throttle/choke control to the SLOW position.
4. Turn the ignition key to OFF. Remove the key.
WARNING
B
A
17
en