Driver-Related Problems - Korg ZERO Manuel D'utilisation

MIDI
MIDI sequencer will not synchronize / MIDI control does not
work
❑ Are the MIDI cables connected correctly?
❑ Could a MIDI cable be broken?
❑ Are the synchronization-related settings of your MIDI
sequencer correct?
→ Refer to the owner's manual for your MIDI sequencer.
Can't control via MIDI
❑ Is the device receiving the control change set to receive
MIDI channels 1–16?
Crossfader or MIDI controller operates incorrectly, or the
touch panel operates incorrectly or fails to operate
❑ You may be able to solve the problem by returning the
system to the factory-set condition.
To return the system to the factory settings, hold down the following
buttons while you turn on the power.
While holding down the mixer channel 7 Cue button and the mixer
channel 8 Cue button, turn on the power.
FireWire
The computer does not detect the ZERO8
❑ Is the FireWire cable connected correctly?
❑ It is possible that the operating system of your com-
puter has become unstable. Power-off your computer
and the ZERO8, and then turn the power back on again.
An error occurs when you disconnect from the computer
❑ Never disconnect the ZERO8 from the computer while
your host application is in use.
While connected, you are asked to install software or a device
driver
❑ Does the operating system version of your computer
support the ZERO8?
Starting up ZERO Edit or transferring MIDI is sometimes
unsuccessful
Noise or crackling occurs when recording or playing-back on
the computer
❑
Are you using a USB-connected peripheral device?
If you are using a USB peripheral device such as an external USB hard
disk, communication errors may occur in FireWire MIDI transmission,
or there may be crackles or noise in the sound during recording or
playback. If this occurs, please disconnect any unnecessary peripheral
equipment.
❑
Are you using a wireless LAN?
If you are using a wireless LAN, FireWire MIDI communication errors
may occur, or there may be crackles or noise in the playback or record-
ing. If this occurs, turn off your wireless LAN while using the ZERO8.

Driver-related problems

Can't install the KORG FireWire Audio/MIDI driver success-
fully
❑ Could another FireWire (IEEE1394) device be con-
nected?
Disconnect all FireWire devices other than the ZERO8 from your com-
puter when you perform the installation. If the ZERO8 is connected to
an external FireWire hard disk, connect the ZERO8 directly to the
FireWire connector (IEEE 1394 connector, iLink connector, DV connec-
tor) on the computer itself.
❑ Could other software programs or resident software
(such as anti-virus software) be running?
It may be impossible to perform the installation successfully if other
programs are running. Exit all other programs before you begin the in-
stallation.
31