Parts Of The Zero8; Top Panel - Korg ZERO Manuel D'utilisation

2. Parts of the ZERO8

Top panel

1–10
1. INPUT SELECTOR knob
Selects the input jack or FireWire audio signal that will be assigned to
the mixer channel. With this knob in certain positions, the send knobs,
pan knob, EQ knobs and/or faders will operate as MIDI controllers.
2. GAIN knob
Adjust the gain of the audio input assigned to the mixer channel.
TIP: If the MIC input level is too high, causing the sound to dis-
tort, press the rear panel MIC GAIN switch to change the mic
preamp gain to LOW.
3. EQ SELECTOR knob
Selects the type of EQ. Switching the EQ type will change the function
of the EQ knobs or vary the tonal character that occurs when adjusting
each of the HI/MID/LO frequency bands.
6
4. EQ knobs
Normally, the HIGH, MID, and LO knobs
boost or cut the sound in each frequency
range. The MID-FREQ knob changes the
center frequency of the MID range. Depend-
ing on the type of EQ selected in the previ-
ous step, the function of the knobs may
27
change.
28
5. PAN knob
11
12, 13
Adjusts the left/right audio balance.
14–16
6. SEND knobs
EXT1, EXT2: Adjusts the send levels to the
17–20
effect processors connected to the EXT
21
SEND1/2 jacks.
22
ZERO FX SEND: Adjusts the send level to
the internal send effect (ZERO FX SEND).
7. SOLO/CUT switch
23
If you set this switch to the SOLO position,
only the sound of that mixer channel will be
24, 25
sent from the master out. The sound of the
26
other mixer channels will not be output.
TIP:
If you hold the switch in the CUT position,
the sound of that mixer channel will be
muted.
TIP:
8. CUE button
When the CUE button is lit (ON), the pre-
fader sound of that mixer channel will be
sent to the CUE bus. By setting the MONI-
TOR BAL knob toward CUE, you can moni-
tor the sound of the CUE bus through head-
phones.
More than one mixer channel can
be set to SOLO.
You can't leave the switch set to the
CUT position.
1
2 3
5
4
6
7
8
9
10