Turning The Power On; Turning The Power Off; Using The Mixer; Selecting The Inputs - Korg ZERO Manuel D'utilisation

Turning the power on

When powering-on the ZERO8, you must use the following order.
1. Connect the power cable.
Connect the included power cable to the power inlet.
2. Power-on the external equipment that's connected to
the input jacks.
3. Turn down the ZERO8's MASTER volume knob.
4. Turn on the power switch located on the ZERO8's rear
panel.
5. Power-on your monitor amp and the amp that is con-
nected to the MASTER OUT jacks.

Turning the power off

1. Turn down the ZERO8's MASTER volume knob.
2. Turn off the power of your monitor amp and the amp
connected to the MASTER OUT jacks.
3. Turn off the power switch located on the ZERO8's rear
panel.

2. Using the mixer

Selecting the inputs

Here's how to assign a set of input jacks to a specific mixer channel.
1. Use the top panel INPUT SELECTOR knob to select the
desired input.
The knobs of each mixer channel for which you selected an audio in-
put will light orange.
Knobs that are operating as MIDI controllers will light blue.
PHONO 1, 2, 3
MIC 1, 2
GUITAR
LINE
CD/LINE
FireWire AUDIO
FireWire AUDIO + MIDI Selects the sound from the com-
MIDI CONTROL
Select the sound from the devices
connected to the PHONO 1 jacks,
PHONO 2 jacks, or PHONO 3
jacks respectively.
Select the sound from the devices
connected to the MIC 1 jack or MIC
2 jack respectively.
Selects the sound from the device
connected to the GUITAR jack.
Selects the sound of the device con-
nected to the LINE jacks.
Selects the sound of the device con-
nected to the CD/LINE jacks.
Selects the sound from the com-
puter connected to the FireWire
connector.
puter connected to the FireWire
connector. In this case, the SEND
(EXT 1, EXT 2, ZERO FX SEND)
knobs and PAN knob will operate
as MIDI controllers.
The controllers of the mixer chan-
nel will operate as MIDI control-
lers.
11