Rear Panel - Korg ZERO Manuel D'utilisation

26. Crossfader
Crossfades the sounds that are assigned to the crossfader's channel A
and channel B, and outputs the result to the master bus.
27. Master level meters
These are needle-style meters that indicates the output from master
outs (Left and Right). If clipping occurs, the red LED will light; adjust
the master out level so that this indicator does not light.
28. FireWire indicator
If the ZERO8 is connected to your computer via a FireWire cable, this
indicator will light when the connection is detected.
Tip: Start up your host application after this indicator has lit.
Handling the LCD display
Never apply strong pressure to the LCD display or place heavy objects
on it. Rough handling may crack or break the LCD display.
Use only your fingertip to operate the display, since scraping or rub-
bing the surface may scratch it. If the display should require cleaning,
wipe it gently with a soft dry cloth. Do not use an organic solvent such
as thinner, since this may cause deformation.
8

Rear panel

10–13
19 18 14–17
1. INPUT 1–8 (LINE) jacks
These are 1/4" TRS phone-type balanced input jacks.
Balanced TRS phone plug
GND COLD HOT
2. INPUT 1–8 (CD/LINE) jacks
These are RCA-type unbalanced input jacks.
3. PHONO 1–3 jacks, GND terminal
These are phono input jacks for connecting turntables; a grounding
terminal is also provided.
4. MIC1, MIC2 jacks
Two types of jacks are provided: TRS
phone jacks and XLR jacks (with +48V
phantom power supply).
If you connect the TRS phone jacks, the
XLR jacks cannot be used.
5. MIC GAIN switches
48These set the mic preamp gain for the MIC 1 and MIC 2 jacks.
6. +48V PHANTOM switches
These turn phantom power on/off for the MIC 1 and MIC 2 jacks.
8, 9 7 4–6 3
Unbalanced phone plug
GND HOT
2: HOT
1: GND
3: COLD
1
2