Using the ZERO8 at the 192 kHz sampling rate
By starting up the ZERO8 in the special 192 kHz audio mode, you can use
it as a high-quality 24-bit/192 kHz 8-in/8-out audio interface.
Note: When using Mac OS X, the 192 kHz sampling rate is not
supported.
Starting up in 192 kHz audio mode
While holding down the SETUP button, turn on the power.
Note: If you start up in 192 kHz audio mode, you won't be able to
switch to other sampling rates (44.1 kHz, 48 kHz, 96 kHz).
If you want to switch to a different sampling rate, you must
turn off the power and then turn the power on again to start
up in the normal way.
Limitations in 192 kHz audio mode
The specifications are limited as follows when operating in the special 192
kHz mode.
• Number of channels: Four stereo channels (8-in/8-out)
• Channel EQ: Not available
• EXT 1, EXT 2 SEND/RETURN: Not available
• Internal effects (CH, SEND, MASTER): Not available
Controller operation when in 192 kHz audio mode
Channel controller
INPUT SELECTOR
GAIN
EQ SELECTOR
HI
MID-FREQ
MID
LO
PAN
EXT1(SEND)
EXT2(SEND)
ZERO FX SEND
18
CH1–4
CH5–8
Operates normally
Not available
Operates normally
Not available
MIDI controller
MIDI controller
(transmits program change messages)
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
SOLO
Operates normally
MUTE
Operates normally
CUE
Operates normally
A
Operates normally
B
Operates normally
CH FADER
Operates normally
Master controllers
CROSSFADER
EXT1(RETURN)
EXT1(RETURN) CUE
EXT2(RETURN)
EXT2(RETURN)CUE
ZERO FX(RETURN)
ZERO FX(RETURN)CUE
MONITOR BAL
MONITOR LEVEL
BOOTH
MASTER
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
MIDI controller
Operates normally
Not available
Not available
Not available
Not available
Not available
Not available
Operates normally
Operates normally
Operates normally
Operates normally