Midi Control Change Message Settings - Korg ZERO Manuel D'utilisation

1: NUMBER (NUM:) .... [1...8] Select one of the preset crossfader curves.
2: POSITION ............. [0...127] Specify the position at which the
crossfader value will be at maximum.
3: CURVE ................ [-64...+63] Specify the shape of the crossfader curve.

MIDI control change message settings

3. CONTROL
Here you can make MIDI controller settings for when using push-knobs 1–
8 as MIDI controllers. From the setting main page, press the CONTROLS
button in the LCD display to access the CONTROLS page.
KNOB A–D
Specify the MIDI control messages that will be transmitted when you turn
push-knobs 1–8 as encoders.
1: NEXT .................................... Shows the next page.
2: NO. ......................... [0...127] Assigns a control change message to each
push-knob.
3: MIN ........................ [0...127] Specifies the minimum control change
value for each push-knob.
4: MAX ....................... [0...127] Specifies the maximum control change
value for each push-knob.
5: PREV .................................... Shows the previous page.
6: MIDI CH .................. [1...16] Specifies the MIDI channel for each push-
knob.
7: BEHAVIOR ...... [ABS, REL] Specifies the operation mode for each
push-knob.
ABS: The knob will operate in absolute value
mode.
REL: The knob will operate in relative value
(sign bit) mode.
Turning the knob toward the right (when
increasing) will transmit values of 1, 2, 3,
..., 64. Turning the knob toward the left
(when decreasing) will transmit values of
65, 66, 67...127.
Note: If you select "REL" (relative value mode), make sure that your
software supports this type of operation.
SW A–D
Here you can specify the MIDI control messages that will be transmitted
when you press push-knobs 1–8 as switches.
1: NEXT .................................... Shows the next page.
2: NO. ......................... [0...127] Assigns a control change message or note
number to each switch.
3: OFF VAL ................ [0...127] Specify the value of the control change that
will be transmitted when each switch is
turned off. If you've selected "NOTE" as
the type, this is fixed at note-off.
4: ON VAL ................. [0...127] Specify the value of the control change that
will be transmitted when each switch is
turned on. If you've selected "NOTE" as
the type, this specifies the note-on velocity
value.
23