Error Messages - Burkert 8600 Notice D'utilisation

4 OPERATION

4.8 Error Messages

The device gives out an error message if the quantity to be filled is less that the previously
calculated quantity resulting from blade wheel afterrun.
Example : The afterrrun of the blade wheel was calculated as 20 pulses at a set quantity
which requires only 10 blade wheel pulses. This means that the fill quantity resulting from
blade wheel afterrun is actually more than the set quantity. In this case, the device would
produce an error message.
Responses : In this case, filling to the set quantity is no longer possible and the message
"E-1", standing for ERROR 1 will be displayed.
The error message can be cancelled by resetting the fill quantity.
Fig. 5 Standard mode
50.00
Standard mode
50 .00
Reference quantity
has been reached.
Valve still open
8600
00.00
After the Start-Sop
key has been
pressed, the fill
process begins
50 .00
Valve closed. Check
for blade wheel
afterrun
-28-
25
.34
The amount filled so far is
displayed. The bar graph
shows this value as a % of
the reference quantity.
50 .00
Quantity has been
filled. Program returns
to start state.