Operation; Display And Control Elements - Burkert 8600 Notice D'utilisation

4 OPERATION

Operation without type 1077-4 operator unit
When used without the type 1077-4 operator unit, the device can be operated via the two
START/STOP and RESET binary inputs. Howerver, no values can be reporgrammed, so
that only the same quantity can be filled each time. The type 1077-4 operator unit is needed
to change any values.
Operation with the type 1077-4 operator unit
The operator unit is fixed onto the type 8600 metering device in place of the cover. It can
be rotated 1800 in each direction.
The voltage supply must be switched off before installing the operator unit.
!
Otherwise this can result in a re-programming and thereby cause the metering
device to lose some functions.
Three modes are possible when operating with the operator unit :
Standard mode
Programming mode
Teach-In mode
When the metering device is switched off, it sotres the last data that were set. When the
operator unit is installed, all necessary data are transmitted to it and stored.
When the programming or teach-in mode has been completed, all set data are transmitted
from the operator unit to the batch controller. When this is completed, the 8600 can be
operated without he 1077-4 operator unit.

4.1 Display and Control Elements

State of valve - open or
closed
4 1/2 digit display for fill
quantity. Wen -.- is
displayed, this indicates
that the fill quantity was
not entered following an
input in the teach-in mode
Bargraph showing, as a
proportion of the fill
quantity, the quantity that
has so far been filled.
Strt key
Amend values
8600
x1 x10
188. : 88
-24-
Not used
Indicates programming and
teach-in modes
Reset key
Verify values