Teach-In-Mode; Filing With Teach-In; Setting The Fill Quantity; Instructions On Operation - Burkert 8600 Notice D'utilisation

4 OPERATION
4.5 Teach-in-Mode (Fig. 7)
The teach-in mode allows two procedures to be carried out :
- the determination of the sensor fitting factor for a specific installation
- the input of a reference quantity without inputting a numerical value
For this, am etering process must be performed manually (see §4.5.1)
There are two possibilities after the fill process is completed :
- If the filled quantity is input hte fitting factor is automatically calculated from these data.
- If the fill quantity is not input into the device, this is retained as the reference quantity, but
not fitting factor is calculated. This reference quantity cannot be changed unless a new
teach-in process is performed.
4.5.1 Filling with Teach-In
Pressing the Reset key for 2 seconds whilst in programming mode will switch the device
to teach-in mode.
If the Start key is now held down, the valve is opened and the fill quantity is registered.
Releasing the key will close the valve again. If the required quantity has been filled, the
teach-in mode can be quit by pressing the Reset key.

4.5.2 Setting the Fill Quantity

The quantity set during teach-in may now be input (not obligatory). Input is done in the
same way as setting the fill quantity in programming mode. After the last value has been
set, the fitting factor is calculated and the device returns to standard mode.

4.6 Instructions on Operation

The operator unit can be removed from the type 8600 metering device, e.g. after
programming has been completed, without affecting the set process. The programmed
values remain stored in the metering device.
The cover must then be placed back on the device and screwed in place.
4.7 Metering Device Settings on Delivery
Multiplier :
Fitting factor:
Fill quantity:
8600
x1
46,60 (pulse/l)
1,00
-27-