5
If your milk starts to fl ow before the
end of the two minutes, press
to change to the expression phase.
¥ Make sure that the milk fl ows
into the bottle properly.
3
Close the bottle with a lid
(depending on bottle type).
¥ Follow the instructions in
Section 13 "Storing, preparing
and feeding breastmilk".
If you are experiencing low or no
suction, refer to Troubleshooting
Section 14, pages 31-32.
Questions? Visit www.medela.com or call us at 1-800-435-8316.
6
Set vacuum comfort: Rotate the
vacuum to the right and increase
until there is slight discomfort.
Rotate to the left to reduce the
vacuum slightly.
Caution
• Contact your healthcare professional
or lactation professional if you can
express only minimal or no milk or if
expression is painful. See Section 10
and 16 for more information.
• Do not try and express with vacuum
that is too high and uncomfortable
(painful). The pain, along with
potential breast and nipple trauma,
may decrease milk output.
Note
• Press the "Let down" button
revert from the expression phase to
the stimulation phase if necessary.
If milk has not begun to fl ow after
two successive stimulation phases,
take a break and try again in 15–30
minutes.Try breast massage (ask your
lactation professional or health care
practitioners) and then pump using the
expression phase.
• The program stores the last vacuum
setting in the stimulation phase.
to
27