After-Sales Service - Hofmann EEWB746A Mode D'emploi

97
Trouble shooting
H90
Wheel acceleration was too slow, or braking was too
weak after a measuring run.
if the main shaft does not reach the required speed,
check that the brake is not activated or the weight of
the wheel is too great. in this case:
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Turn the wheel by hand then press the START key.
if the error cannot be eliminated, call the service
team.
H91
Speed variations during measuring run. The brake
may be oN.
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Repeat the run.
7.2

After-sales service

Contact your area agent.
The company website provides information about the
Customer Assistance service around the world:
Snap-on Equipment
309 Exchange Ave.
Conway AR 72032
Tel. 501-450-1500
Fax: 501-450-1585
Operator's Manual
EEWB746A