Table des Matières
Publicité
77
5-46a
5-47
5-48
5-49
5-50
Operation
Fig. 5-46a oPTiMiSATioN "OP.10", outside
Rotate the wheel into marking position following the
arrows.
in this position provide a double mark on the tyre
outer side exactly perpendicular to and above the main
shaft.
Confirm by pressing menu key F1.
The oPTiMiSATioN "OP.11" screen (Fig. 5-48) is displayed.
Fig. 5-47 oPTiMiSATioN "OP.10", inside
if the tyre is not to be turned over on the rim, press F2.
Continue as shown on screen oPTiMiSATioN "OP.10"
(Fig. 5-46a).
Rotate the wheel into marking position following the
arrows.
in this position provide a double mark on the inside of
the tyre, exactly perpendicular to and above the main
shaft.
Turn the tyre over on the rim.
Confirm by pressing menu key F1.
The oPTiMiSATioN "oP.11" screen (Fig. 5-48) is
displayed.
Reading H 0
optimum condition has been achieved and cannot be
improved.
Reading H 2
Wheel running conditions cannot be improved. However, it
is possible to achieve weight minimisation
Fig. 5-48 oPTiMiSATioN "OP.11"
Readjust the tyre on the rim such that the double mark
coincides with the valve (use tyre changer).
Confirm by pressing menu key F1.
The oPTiMiSATioN "oP.12" screen (Fig. 5-49) is
displayed.
Operator's Manual
EEWB746A
Publicité
Table des Matières
