Table des Matières
Publicité
75
5-43
5-44
5-45
5-46
5-47
Operation
Fig. 5-43 oPTiMiSATioN "OP.7"
Readjust the tyre on the rim such that the single mark
coincides with the valve (use tyre changer).
Confirm by pressing menu key F1.
The oPTiMiSATioN "OP.8" screen (Fig. 5-44) is displayed.
Fig. 5-44 oPTiMiSATioN "OP.8"
(3rd measuring run of tyre/rim assembly)
Clamp the wheel on the balancer.
Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
Enter the valve position by pressing menu key F1.
The oPTiMiSATioN "OP.9" screen (Fig. 5-45) is displayed.
Fig. 5-45 oPTiMiSATioN "OP.9"
START is signalled on the screen.
Press the START key.
A measuring run is performed.
The screen oPTiMiSATioN "OP.10", outside (Fig. 5-46)
or the screen oPTiMiSATioN "OP.10", inside (Fig. 5-47) is
displayed.
Reading H 0
optimum condition has been achieved and cannot be
improved.
Continue as shown on screen BALANCiNG
(Fig. 5-51).
Reading H 2
Wheel running conditions cannot be improved. However, it
is possible to readjust the tyre relative to the rim to obtain
a quite considerable minimisation of balance weights (i.e.
smaller weights) without having an adverse effect on wheel
running conditions.
Continue as shown on screen oPTiMiSATioN "OP.10"
(Fig. 5-46).
Operator's Manual
EEWB746A
Publicité
Table des Matières
