Technical Data - Rothenberger ROPOWER 50 R Mode D'emploi

Do not allow any persons who are not employed by the company or uninstructed
persons to operate / touch the machine and tools or the mains power cable!
If the machine is not to be used for some time, it is essential to switch it off and to pull
out the mains cable!
Before changing the cutting heads, the cutting wheel, the pipe deburrer, always switch
off the machine and pull out the mains plug (de-energised operation!)!
After it has been switched off, the machine still coasts for a while until it comes to a
standstill.
Do not touch any parts before the machine is completely stationary and the mains plug
has been pulled out!
If the machine is being cleaned, maintained, inspected or repaired , it is essential to
switch it off and to pull out the mains plug (de-energised operation)!
Always avoid uncontrolled starting-up of the machine. Risk of injury and accidents!
Before setting up the thread-tapping machine, read these operating instructions through
carefully and in full. You must fully understand the warnings, instructions and lists they
contain concerning fault-free, safe operation and operating the machine, as well as
those relating to your safety!
Keep the operating instructions in a clean, dry place and within easy reach. If the used
machine is sold, European regulations dictate that these operating instructions must
always be given to the purchaser!
In the case of the threaded pipes, carry out a pressure test in order to ensure that no gas
or water can escape after the pipes are fitted!
2.

Technical data

Art.-No. 5.6050
Art.-No. 5.6045
Cutting capacity:
Speed:
Motor:
Protection class:
Frequency:
Weight:
Dimensions:
Thread-tapping head:
Thread jaws:
30
ROPOWER 50 R, 230 V
ROPOWER 50 R, 110 V
BSPT R ¼" ... 2"
40 rpm under no load
Single-phase universal motor 1150 W, overload protection
I
50/60 Hz
44 kg (without accessories)
535 x 430 x 340 mm (LxWxH)
Automatic tapping head ½" ... 2"
½" ... ¾", 1" ... 2"
Optional ¼" – 3/8" (Art.-no. 5.6369)