Daily Inspection - Rothenberger ROPOWER 50 R Mode D'emploi

Pull the clamping jaw insert forward.
Remove the other two clamping jaw inserts if three clamping jaw inserts must be replaced at the same time.
Remove chips, dirt, oil etc. from mounting surface of the clamping jaw inserts.
Insert a new clamping jaw insert and push it right to the back, replace the spring and the clamping chuck pin.
Tighten the screw.
Install the two other clamping jaw inserts in the same way.
6.4

Daily inspection

- Check the mains plug, mains cable and extension cable to ensure they are undamaged.
- Correctly filled oil trough
- Adjust the oil screw if necessary
- Clean the oil tank if there are impurities in it.
- Inspect the thread-tapping jaws, pipe cutter and internal deburrer for any wear and replace parts if there is
wear.
- Clean the clamping jaws with a wire brush if they are dirty.
- Check that the dowel screws are secure. Tighten if necessary.
- Remove dirt and chips from the machine regularly.
- Apply anti-rust grease if the machine is not going to be used for an extended period.
- Lubrication of spindle support:
The rear spindle support has to be lubricated periodically.
Attention! Before starting the lubrication-works the power plug has to be taken out of the
power source.
The lubrication is only allowed for persons which have been supervised in electrical safety issues.
Clamping jaw
inserts
Remove
47