Product Description; Operating Range And Intended Use; Technical Data; Overview - Rothenberger 53240 Instructions D'utilisation

3

Product Description

3.1

Operating Range and Intended Use

The Pipe Scraping Tool was developed specifically for worksite use and is designed for the
preparation of pipes prior to electrofusion welding.
Operating range of the Size 1 tool:
O.D. 32, 40, 50, 63, 75, 90, 110, 125, 140, 160 mm
Operating range of the Size 2 tool:
O.D 110, 125, 140, 160, 180, 200, 225, 250, 280, 315, 355, 400, 450, 500 mm
Any and all other uses are considered unintended. The manufacturer cannot be held
responsible in any circumstances for such damage as may result from unintended use, which
is at the user's exclusive risk.
3.2

Technical Data

Pipe Peeler/Scraper
Weight: .......................................... ca. 2,3 kg ................................. ca. 5,8 kg
Operating Range O.D.: ................. 32 - 160 mm ............................. 110 - 500 mm
Transport Case:
Dimensions: ........................... 330 x 250 x 130 mm ................. 450 x 365 x 185 mm
Weight: ................................... ca. 2,5 kg ................................. ca. 4,5 kg
3.3

Overview

Horizontal Knob (Manual Drive of
1
Scraping Spindle)
2 Vertical Knob (for Clamping Tool to Pipe) 8
3
Scraper Guide with Blade Holder
4 Locking Lever
5 Horizontal Spindle (Scraping Spindle)
6
Outside-pipe Bearing
3.4

Parts and Accessories

The following parts and accessories are shipped at delivery:
1 x Transport Case
1 x Key T 6 x 50
1 x Specialty Grease
1 x User's Manual
4

Operation

 Using a suitable pen, mark the edge of the electrofusion fitting (the length of pipe butt to
be inserted into the fitting) on the pipe.
 Unlock the locking lever and position the scraping guide at the back.
 Push the pipe scraper onto the pipe all the way to the vertical attachment and secure it by
tightening the vertical knob loosely.
 Actuate the quick-release and position the scraping guide where peeling/scraping should
start.
 Unlock the locking lever and push the guide and blade holder down to a blade height
reading of approx. 3 - 4 mm.
8
Size 1
7
9
10
11
12
ENGLISH
Size 2
Inside-pipe Bearing
Vertical Attachment (Pipe Stopper)
Threaded Safery Bolt
Blade Height Adjuster
Quick-release/Spindle Locking Nut
(behind locking lever)
Two-blade Turning Bi