Fitting Instructions - R&G FP0224 Notice De Montage

PAGE 3 OF 9

FITTING INSTRUCTIONS

•
On the left-hand side of the motorcycle (as you sit on it) fit the LHS spacer (item 2) into
the recess on the left-hand side of the front spindle.
•
Fit one nut and washer (items 5 and 6) onto the spindle bar (item 3) (the end with short-
er thread) and engage the nut so the plastic insert of the nut is fully engaged.
•
Feed the spindle bar with nut and washer through either crash protector (item 1) and
through the spacer just fitted.
•
Place the RHS spacer (item 4) over exposed right-hand end of spindle bar so the recess of
the spacer fits over the spindle nut and then slide the remaining crash protector (item 1) onto
the spindle bar.
•
Fit the remaining washer and nut (items 5 and 6) from the kit onto the thread and tighten
until both nuts are engaged in nylon and equal amounts protrude from either side. Do not
overtighten - the nyloc nuts will hold it tight.
•
Check the fork protectors are secure and held firmly against the spacers and do not spin.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may
make design changes which do not diminish their performance or visual appeal and supplying them in such state
shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has been
given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has cho-
sen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Prod-
ucts or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless
the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is
not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or
maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or
if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability
for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do
not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct
to us if they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original
vendor. Goods must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% re-
stocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The cus-
tomer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of pur-
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire GU34 3AQ.
Tel: +44 (0)1420 89007 Fax +44 (0)1420 87301
Issue 1 11/09/2019 (BG)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com Email:
FP0224
info@rg-racing.com