FITTING INSTRUCTIONS FOR LP0241BK LICENCE PLATE BRACKET
YAMAHA MT-09 2017 (FOR USE WITH STANDARD AND R&G MINI
Page | 1
THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.
DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.
Please note that the way the kit is packed does not necessarily represent the way of
T
HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY
Digital copies of these instructions are available to download from
Please note that in cases where kits are packed with rubber washers holding the components
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
INDICATORS (8mm))
mounting to the bike
GENERAL TORQUE SETTINGS
M4 BOLT = 8Nm
M5 BOLT = 12Nm
M6 BOLT = 15Nm
M8 BOLT = 20Nm
M10 BOLT = 40Nm
onto the bolt – the rubber washers should be thrown away!
TOOLS REQUIRED
Set of metric Allen keys to include 4, 5 and 6mm A/F sizes.
6, 8, 10, 12, 13 & 27mm spanners or sockets and wrench.
Electrical pliers/crimps.
Small amount of super glue.
Rear paddock stand and cotton reels.
R&G Racing
(
FOR CLARITY OF INSTRUCTIONS ONLY
www.rg-racing.com
Phillips driver.
www.rg-racing.com
Email:
1
LP0241
)
info@rg-racing.com