Cut-Off Machine Cart; Storing The Machine - Stihl TS 700 Notice D'emploi

7
8
Carefully fit a new poly V-belt (7) in
N
the cast arm and insert it in the front
poly V-belt pulley (8) on the engine
Fit the starter cover
N
Position the "support with guard"
N
against the cast arm
Fit the poly V-belt in the front poly V-
N
belt pulley (9)
Position belt guard
N
Align the studs in the support with
N
the nuts in the V-belt guard
Screw the nuts onto the studs – do
N
not tighten them yet
Place hose in the guide of the
N
starter cover
Continue as described in the chapter
"Tensioning the V-belt".
TS 700, TS 800

Cut-off Machine Cart

9
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
repair damaged roadways
–
apply roadway markings
–
cut expansion joints
–

Storing the Machine

If the machine is to remain out of use for
approx. 3 months or more
Drain and clean the fuel tank in a
N
well ventilated place
Dispose of fuel in accordance with
N
the regulations and having regard
for the environment
Run the engine until the carburetor
N
is dry, this helps to prevent the
carburetor diaphragms sticking
together
Remove the abrasive wheel
N
Thoroughly clean the machine,
N
especially the cylinder fins
Store machine in a safe and dry
N
place. Protect against unauthorized
use (e. g., by children)
English
35