Spark Plug - Stihl TS 700 Notice D'emploi

Spark arresting screen fastened with
clip
Use a suitable tool to squeeze ends
N
of clip (1) together and then lift the
clip away
Remove the spark arresting
N
screen (2) from the muffler
Clean the spark arresting screen if
N
necessary
If the screen is damaged or heavily
N
carbonized, fit a new one
Refit the spark arresting screen in
N
reverse order of steps
Spark arresting screen fastened with
screw
2
1
Undo screw (1)
N
Pull out spark arresting screen (2)
N
with a suitable tool
Clean the spark arresting screen if
N
necessary.
TS 700, TS 800
If the screen is damaged or heavily
N
carbonized, fit a new one
Refit the spark arresting screen in
N
reverse order of steps

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the spark plug
Switch off the engine – move stop
N
switch to STOP or 0
Unscrew the screw (1) and remove
N
cap (2) – screw (1) is secured in the
cap (2) to prevent loss
3
4
Remove the spark plug boot (3).
N
Unscrew the spark plug (4).
N
English
33