Engine Management; Adjusting The Carburetor - Stihl TS 700 Notice D'emploi

Engine Management

Exhaust emissions are controlled by the
design of the engine and components
(e.g. carburation, ignition, timing and
valve or port timing).
TS 700, TS 800

Adjusting the Carburetor

Basic information
The ignition system of this cut-off
machine is equipped with an electronic
speed limiter. The maximum speed
cannot be increased beyond a specified
limit.
The carburetor is equipped with a
factory-installed standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
Preparations
Shut off the engine
N
Check the air filter – clean or replace
N
it if necessary
Check the spark arresting screen in
N
the muffler (present only in some
countries) – clean or replace it if
necessary
Standard Setting
L
Turn the high speed adjusting
N
screw (H) counterclockwise as far
as possible – max. 3/4 turn
Turn the low speed screw (L)
N
clockwise as far as possible, then
turn it back 3/4 turn
Adjust idle speed
Carry out the standard setting
N
Start the engine and run until it is
N
warm
L
The engine stops at idling speed
Turn the idle speed adjusting
N
screw (LA) clockwise until the
abrasive cutting wheel begins to
turn – then turn it back 1 turn
English
31