Diamond Abrasive Wheels - Stihl TS 700 Notice D'emploi

Diamond Abrasive Wheels

For wet applications.
The proper selection and use of
diamond abrasive wheels ensures
economical use and avoids accelerated
wear. The product code which appears
on the label and
–
on the packaging (table with
–
recommendations for use) is an aid
to selection
STIHL diamond abrasive wheels are
suitable, depending on the version, for
cutting the following materials:
Asphalt
–
Concrete
–
Stone (hard stone)
–
Abrasive concrete
–
Fresh concrete
–
Clay brick
–
Clay pipe
–
Ductile cast iron pipe
–
Do not cut any other materials – Risk of
accident!
TS 700, TS 800
Never use diamond abrasive wheels
with side plating as they jam in the cut
and can result in extreme kickback –
Risk of accident!
Product Codes
D-B10
The product code is a combination of
letters and numbers, consisting of up to
four characters:
the letters denote the main field of
–
application of the abrasive wheel
the numbers denote the
–
performance class of the STIHL
diamond abrasive wheel
Axial and radial run-out
A faultless spindle bearing of the cut-off
machine is necessary for a long service
life and efficient functioning of the
diamond abrasive wheel.
Using the abrasive wheel on a cut-off
machine with a faulty spindle bearing
can lead to deviations in radial and axial
run-out.
An excessively high radial run-out
deviation (A) overloads individual
diamond segments, which overheat in
the process. This can lead to stress
cracks in the parent wheel or to
annealing of individual segments.
Deviations in axial run-out (B) result in
higher thermal loading and wider cuts.
Undercut
Do not cut into the base course
(frequently chipped stones and gravel)
when cutting roadway pavement –
cutting in chipped stones and gravel is
revealed by light-colored dust –
excessive undercut may occur as a
result – Danger of shattering!
English
15