Replacing The V-Belt; Cut-Off Machine Cart - Stihl TS 700 Notice D'emploi

Replacing the V-belt

4
2
6
1
5
6
6
N
The arrow on the tensioning nut (1)
must point to 0 – to this end, turn the
tensioning nut (1) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
N
Remove screw (2)
N
Pull the V-belt guard (3) off to the
front and remove the poly V-belt
from the front pulley.
N
Remove the "bearing and guard".
N
Remove the hose (4) from the guide
of the starter cover (5)
N
Remove the screws (6) from the
starter cover
N
Remove the starter cover
N
Remove the defective poly V-belt
from the cast arm
TS 700, TS 800
3
N
Carefully fit a new poly V-belt (7) in
the cast arm and insert it in the front
poly V-belt pulley (8) on the
shortblock
N
Fit the starter cover
N
Hold the bearing with guard against
the cast arm
N
Fit the poly V-belt in the front poly V-
belt pulley (9)
N
Slide on the V-belt guard
N
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
N
Screw in the hexagon bolts, but do
not tighten them yet
N
Place hose in the guide of the
starter cover
Continue as described in the chapter
"Tensioning the V-belt".

Cut-off machine cart

The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
– repair damaged roadways
– apply roadway markings
– cut expansion joints
English
31