Safety Instructions For Maintenance/Troubleshooting; Notes Regarding Special Types Of Hazard - Kemper 83 200 110 Mode D'emploi

2.5 Safety instructions for maintenance/troubleshooting

Service and maintenance doors must be freely accessible at all times.
Setting up, maintenance and repair work and troubleshooting must only
be performed when the product is switched off.
Always tighten bolt connections that have been loosened during repair
work. If specified, tighten the relevant bolts with a torque wrench.
In particular, protect connections and screw connections from dirt or care
products at the beginning of maintenance/repair/care
The time frames for periodic testing/inspections stipulated or specified in
the operating instructions must be observed.
Before disassembling, mark the parts that belong together.

2.6 Notes regarding special types of hazard

WARNING
Health hazards caused by welding fume particles
Skin contact with cutting fumes, etc. can cause skin irritation in
susceptible individuals.
Repair and maintenance work on the product may only be carried out by
trained and authorised personnel while complying with the safety rules
and the applicable accident prevention regulations.
Serious injury to the lungs and respiratory tract is possible!
In order to avoid contact with and inhalation of dust particles, use
protective clothing, gloves and a blower respirator system.
The release of hazardous dust particles during repair and maintenance is
to be avoided to ensure that persons not charged with the task are not
affected.
1502518-00 - 61 -
EN