General Functions; Settings; Language; Function Switch - Danfoss ADAP-KOOL AKC 114 G Mode D'emploi

General functions

Settings

Language

Function switch

(Main Switch)
AKC 114G
Setting of the various functions takes place via a menu system. The menu system is based on
several levels according to the following principle.
The settings are indicated the way they appear in the control panel type AKA 21, e.g.
Level 1 Level 2
Defrost Control Scheduel Def.1 Start Times No. Per Day
The total menu is contained in each of the following documents:
- "Menu operation via AKA 21"
- "Menu operation via AKM".
There are three languages in the controller. English, German and French.
When the required language has been selected, the individual functions will be shown in this
language, both when there is operation via AKA 21 and system software type AKM.
NB! When you operate system software type AKM it is important that the language code is set
before an upload of the controller's data is carried out to the AKM programme (it is the set
language that will be picked up by the AKM programme). Select one of the controller's three
languages by means of the following settings:
0: English
1: German
2: French
Activate the selected language by pushing "Enter" and then push "Clear".
Main Function Main Function Settings
The function switch is used for stopping and starting the regulating function. The switch has
three positions:
- Regulation
- Controller stop
- Service
Main Function Main Function Settings
If the switch is set in pos. 0 or -1, all the controller's functions are inactive. In the menu the
"Standby mode" message is shown, when setting is selected to "0" or "-1". If the switch is in
pos. +1, regulation is started for the functions selected as "ON".
Function description RC.8A.R1.02 © Danfoss 10/2001
Level 3
(Number of defrosts is set)
Def1 Sc1
___
Language
(Setting = +1)
(Setting = 0)
(Setting = -1)
+1/0/-1
Main Switch
(Level 4)
Def1 Sc1 Hour
(Hour value is set)
17