Clock Function; Access Codes; Supporting Text; External Alarm Signal - Danfoss ADAP-KOOL AKC 114 G Mode D'emploi

Clock function

Access codes

Supporting text

External alarm signal

AKC 114G
The controller contains a clock function.
The clock function is only used for the "defrost start with internal clock" function.
Settings have to be made of days, hours and minutes.
AKC --- Adr. Clock
Note:
The clock has to be reset after a power failure.
If the controller is connected to an installation with a master gateway, the gateway will
automatically reset the clock function.
The controller can be operated with system software type AKM and control panel type AKA 21.
Both operating modes may give access to several levels, depending on the user's knowledge
of the various functions.
System software type AKM:
The different users are defined here with initials and passwords. Access is now granted to
exactly the functions the user is allowed to operate.
The operation is described in the AKM manual.
Control panel type AKA 21:
Access can be given to three user levels here:
1) Access without use of password.
See alarms. Display selected temperatures. Change temperature in the refrigeration
appliance. Start defrost.
2) Access via code 1
Setting of selected functions, acknowledgement of alarms.
3) Access via code 2
All settings in the menu system can be performed.
The operation is described in "Menu operation via AKA 21".
If access code is set in pos. "0" (factory setting), there is free access to the system without the
use of a password.
AKC --- Adr.
When the controller is set from control panel type AKA 21, it is possible to show auxiliary text in
the display for a few functions.
This is done by pushing the key "Help" when the required function is shown in the display. A
brief text will now appear which describes the setting. For example:
Function is shown
Finish by pushing "¬", and you will return to the function.
In the menu is shown which functions are provided with auxiliary text.
The controller is provided with a digital input which can be used for digital monitoring of an optional
function. The input is connected to a contact function and will now register if the contact is open
or closed. When the contact is registered as open, an alarm will be given when the time delay has
been exceeded. Together with the alarm, an alarm message may be transmitted via the data
communication. This text may be one of the following five preprogrammed texts found in the
controller:
- DI alarm
- Door alarm
- Safety cutout
- Fan failure
- Leak alarm
The time delay can be set between 0 and 180 minutes.
Function description RC.8A.R1.02 © Danfoss 10/2001
Clock: Day
Clock : Hour
Clock: Min.
___
Chg. Code1
___
Chg. Code 2
Push "Help" Auxiliary line 1 appears
Auxiliary line 2 appears
Push "¯"
etc.
1-7 (1=Monday, 7=Sunday)
0-23
0-59
19