7. Close the upper casing reconnecting the earth connection Fg.11
8. Insert the 2 screws on the sides of the casing removed in phase 1. Finally insert the
4 screws of the cover as in phase 2.
MAKE SURE THE FOUR LAMPS SWITCH ON PROPERLY BY CHECKING THE
CORRESPONDING INDICATOR LIGHTS.
At the end of each maintenance operation, both when replacing the filter and the
lamps, you must report the date and name of the assistance centre which performed
the operation on the label affixed at the side of the device (spare part: code SSAA013).
Trimester N°:
START
1°
2°
3°
Serial number
S/N:
At the end of the lifecycle of the lamps, together with replacement of worn components
(filter and lamps), a new yearly plate will be affixed. ENTER THE DATA ON THE START
AND S/N LINE. If the maintenance intervention is not respected or reported, it will be
necessary to reset the routine maintenance program by replacing the lamps which could
have reached the end of their lifecycle and the filter which could dirty the lamps
reducing their performance.
N.B. Whenever it is necessary to replace the lamps, it is not possible to change only one.
DEMOLITION AND DISPOSAL
Refer to annex
Cod. 0Z00H0004
YEARLY ROUTINE MAINTENANCE
Description of intervention
Installation / changing
lamps and filter
Filter change
Filter change
Filter change
Fg.13
19
Date
ENGLISH
C.A.R.