Composition And Function - Tecno-gaz Tecno Seal Mode D'emploi

2.2

Composition and function

Temperature Controller
Sealing and printing process sequence
1. After the sterilization packaging has been inserted, the feed process is started.
2. The sterilization packaging is now fed and the sealing seam area is heated up to the set
sealing temperature by the heating units located at the top and bottom. The sealing
temperature is monitored.
3. The sealing seam, which is now heated, is pressed together by the sealing roller and
sealed.
4. The finished sterilization packaging is transported to the extraction side.
5. If no item to be sealed is fed in, the feed switches off after approximately 30 seconds
(TA007TAU).
6. The sealing temperature remain saved after the machine is switched on or off, or after a
power failure (auto safe).
Page GB 8
Adjustable sealing edge
setting
Mains fuses
Power connection
Display
Input and function
buttons
9.693.004 V 4.06