Programming Switching Times - Tecno-gaz Sterilair Pro SA210ZSA Manuel De L'utilisateur

Before setting the first program, you must Reset:
Make sure the sliding switch  is at RUN.
1.
2. Press the key R ()with a pointed object.
The display will start to flash 0:00.
Setting time and day
Move the siding switch  to
1.
2. Press the key 1...7 ( ) to enter the day of the week (1 = Monday, 7 = Sunday).
An arrow will appear on the display indicating the day of the week.
3. Use the keys h ( ) and m ( ) to set the time.
Move the switch  to RUN. The time of the day is activated.
4.
Permanently ON, permanently OFF, AUTO
To set these functions, make sure the sliding switch  is at RUN.
Permanently ON: The device is permanently on.
The sliding switch  is at I. The symbol  appears on the Display.
Permanently OFF: The device is permanently off
The sliding switch  is at 0. The symbol  disappears from the Display.
AUTO: The device switches according to the set program. The sliding switch  is at
AUTO.
• ON mode: the symbol  appears.
• OFF mode: the symbol  does not appear.

Programming switching times

The switching in execution or selected will be indicated by a number at the bottom right
of the display with the relative symbol .
Advice for programming: every switch-on point is closely linked to the subsequent
switch-off point. They should always be programmed in pairs to prevent mistakes.
Attention: the shortest switching interval which can be set is 1 minute.
Procedure:
Move the sliding switch  to P .
1.

On
13
ENGLISH
Off