Installation - Tecno-gaz Sterilair Pro SA210ZSA Manuel De L'utilisateur

ENGLISH

INSTALLATION

The device is supplied packed in the cardboard box with recyclable impact-proof material.
Before performing installation, make sure the device is intact. Should signs of
damage caused by transportation be detected, inform the dealer.
ATTENTION UV radiations!
Do not activate the device if there are luminous filtrations towards the
outside. EYES AND SKIN COULD BE HARMED
Keep the packaging at least as long as the warranty is in effect.
The product is intended exclusively for INTERNAL use. It is not suitable for HUMID
environments.
The device must not be used where it can come to contact with water to avoid the risk of
fires or electrical shocks.
The device must not be used in potentially explosive atmospheres.
The device can be hung on a wall or "free standing" mounted on a stand.
Before installing it, make sure there is an electric socket nearby and that it can be reached
to unplug the device before cleaning or maintenance.
The device can be installed at a height close to that indicated in Fg.3, keeping in mind
recognised sources of contamination or areas requiring special protection.
Steril Air PRO standard model (mounted
on the wall) is supplied with a bracket at
the back of the device to allow it to be
fastened to the wall by means of the two
dowels with the L-shaped hooks 9 cm one
from another and approximately 1.8 m
above the ground.
- Minimum Diameter of hole 6 mm
- Minimum depth of hole 40 mm
Technical data on type of dowel:
- Min Screw (diam. x length) 4.2x38 mm
10
Fg.3