Stihl MSA 160 C Notice D'emploi page 33

N Check the depth gauge setting after
each sharpening
1
N Lay the appropriate file gauge (1) for
the chain pitch on the saw chain and
press it against the cutter to be
checked – if the depth gauge
protrudes past the file gauge, the
depth gauge must be reworked
Sharpening tools (special accessories)
Round file ^
Chain pitch
Inches (mm) mm (Inches) Part number
1/4 P (6.35) 3.2 (1/8)
MSA 160 C
All manuals and user guides at all-guides.com
N
Rework the depth gauge so that it is
flush with the file gauge
N Afterwards, dress the leading edge
of the depth gauge parallel to the
service mark (see arrow) – when
doing this, be careful not to further
lower the highest point of the depth
gauge
Round file File holder
Part number
5605 771 3206 5605 750 4300
Depth gauges that are too low
increase the kickback tendency of
the chain saw.
N Lay the file gauge on the saw chain
– the highest point of the depth
gauge must be flush with the file
gauge
N
After sharpening, clean the saw
chain thoroughly, removing any
filings or grinding dust – lubricate
the saw chain thoroughly
N In the event of extended periods of
disuse, store saw chains in cleaned
and oiled condition
File gauge Taper square file Sharpening set
Part number Part number
0000 893 4005 0814 252 3356
English
Part number
–
31