Connection - Sygonix 20815Q Mode D'emploi

7. Connection

The camera has a connection cable with two plugs at the end.
The video signal (PAL) is available at the BNC connector. Use a matching adapter if you cannot
use a BNC video cable.
The camera is connected to the external voltage supply via the low-voltage round sock-
et (direct voltage, 12 V/DC). A matching round plug is required for connection, outer di-
ameter 5.5 mm, inner diameter 2.1 mm. The outer contact of the round plug must
conduct minus/-, the inner contact plus/+.
Incorrect connection or wrong voltages will damage the camera; loss of warranty/guaran-
tee!
If the camera is installed and operated outdoors, the two plug connectors must only be placed in
a location protected from moisture. Observe chapter 6. If this is not observed, there will be corro-
sion of the plug connectors!
Set the correct input channel at the display device for the camera image to be displayed.
If required, align the camera correctly so that you can monitor the desired image section.
The IR LEDs are switched on automatically in the dark. The LEDs are, however, not visible to the
human eye. Observe that the image is displayed in black and white instead of colour on a con-
nected screen at night.
23